The MR Twin Disc Clutch Kits are ideal for high powered, high torqued vehicles. Constructed of a billet pressure plate for increased stiffness and no clamp load deflection
Twin 184 mm disc clutch kits that are designed to hold up to 650 ft/lbs of wheel torque. Designed for track and race vehicles
The MR Twin Disc Clutch Kits are ideal for high powered, high torqued vehicles. Constructed of a billet pressure plate for increased stiffness and no clamp load deflection
Twin 184 mm disc clutch kits that are designed to hold up to 650 ft/lbs of wheel torque. Designed for track and race vehicles
| Weight | 28 kg |
|---|---|
| Dimensions | 15.5 × 15.5 × 5 cm |
| air_freight_prohibited | false |
| not_carb_approved | false |
| ltl_freight_required | false |
| prop_65 | Unknown |
| part_type | automotive |
| epa | N/A |
| carb_acknowledgement_required | false |
| regular_stock | false |
| units_per_sku | 1 |
| upc | 850041702278 |
| brand | DKM Clutch |
| part_number | MR-006-054 |
Conversion kit, will not work with OEM flywheel, built to work exclusively with Clutch Masters flywheel
“Race” (TD7R)2 ceramic rigid discs The Clutch Masters FX725 is a 7.25″ (184mm) Twin Disc clutch and is the ultimate in twin disk performance for engines/transmissions with smaller bell-housings that are focused on drag racing. Clutch Masters FX725 Twin Disc systems are developed from decades of experience in drag racing. Because of the minimal rotational mass the FX725 isn’t ideal for the street but with improvements in friction material over the years we have been able to create a solution that can handle occasional street driving. The FX725 is designed to hold tremendous horsepower and torque, while maintaining reasonable peddle pressure to operate on the track. The cover assembly is machined from billet aluminum and is then Type 3 hard anodized. Our billet covers have roughly 25% more tensile strength than the competition’s cast unit. By focusing our ability on machining the strongest cover possible while maintaining minimal weight, we are basically able to eliminate any flex in the cover.
Conversion kit, will not work with OEM flywheel, built to work exclusively with Clutch Masters flywheel
Conversion kit, will not work with OEM flywheel, built to work exclusively with Clutch Masters flywheel
The cover assembly is machined from billet aluminum and is then Type 3 hard anodized. Our billet covers have roughly 25% more tensile strength than the competition’s cast unit. By focusing our ability on machining the trongest cover possible while maintaining minimal weight, we are basically able to eliminate any flex in the cover. Our billet covers see only .003” of flex where as a cast or stamped unit can see as much as .030” of flex. By eliminating this flex in the cover, the driver is able to operate the clutch much more consistently and confidently. All the movement being applied to the diaphragm of the clutch from the throwout bearing is used solely to engage and disengage the clutch and isn’t wasted by the cover flexing first. The strength of our covers also results in greater clamping force over the same amount of area vs. a cast or stamped cover. This means our twin discs are easy to drive and have superior clamping force to make sure all the power your engine is making is being utilized.
Conversion kit, will not work with OEM flywheel, built to work exclusively with Clutch Masters flywheel
Reviews
There are no reviews yet.